{
    "type": "filament",
    "name": "Bambu TPU 85A @BBL H2D 0.4 nozzle",
    "inherits": "Bambu TPU 85A @base",
    "from": "system",
    "setting_id": "GFSU04_17",
    "instantiation": "true",
    "additional_cooling_fan_speed": [
        "100"
    ],
    "eng_plate_temp": [
        "35"
    ],
    "eng_plate_temp_initial_layer": [
        "35"
    ],
    "filament_cooling_before_tower": [
        "10"
    ],
    "filament_cost": [
        "41.99"
    ],
    "filament_density": [
        "1.22"
    ],
    "filament_deretraction_speed": [
        "50"
    ],
    "filament_flow_ratio": [
        "1.1"
    ],
    "filament_long_retractions_when_cut": [
        "0"
    ],
    "filament_max_volumetric_speed": [
        "2.5"
    ],
    "filament_ramming_volumetric_speed": [
        "0.55"
    ],
    "filament_printable": [
        "2"
    ],
    "filament_retraction_length": [
        "2.3"
    ],
    "filament_retraction_speed": [
        "20"
    ],
    "filament_wipe": [
        "1"
    ],
    "filament_wipe_distance": [
        "1"
    ],
    "filament_z_hop": [
        "0.6"
    ],
    "filament_z_hop_types": [
        "Spiral Lift"
    ],
    "filament_extruder_variant": [
        "Direct Drive TPU High Flow"
    ],
    "filament_pre_cooling_temperature": [
        "195"
    ],
    "filament_ramming_travel_time": [
        "20"
    ],
    "filament_overhang_2_4_speed": [
        "25"
    ],
    "filament_overhang_3_4_speed": [
        "25"
    ],
    "filament_overhang_4_4_speed": [
        "20"
    ],
    "filament_overhang_totally_speed": [
        "25"
    ],
    "impact_strength_z": [
        "88.7"
    ],
    "long_retractions_when_ec": [
        "1"
    ],
    "nozzle_temperature_range_high": [
        "250"
    ],
    "nozzle_temperature": [
        "230"
    ],
    "nozzle_temperature_initial_layer": [
        "230"
    ],
    "override_process_overhang_speed": [
        "1"
    ],
    "slow_down_layer_time": [
        "14"
    ],
    "slow_down_min_speed": [
        "30"
    ],
    "compatible_printers": [
        "Bambu Lab H2D 0.4 nozzle"
    ],
    "filament_start_gcode": [
        "; filament start gcode\n"
    ],
    "filament_end_gcode": [
        "; filament end gcode \n"
    ]
}